Standard light bulb with GU10 or E27 socket

How to Install/Pair a Smart Led E27/GU10

  1. Screw the bulb in place

  2. Make sure that the bulb has power (toggle the power switch if necessary)

  3. Start the scan for new devices in the app

How to configure an SMART LED E27/GU10

  • Click configure on the light bulb after scanning for new devices

  • Set the device name

  • Add the device to a room

    • Select the room you want from the list or add a new room

  • Set the application

Application types

  •  Light - The bulb will be is controlled as part of the room. E.g it will react to the changes you make to light in the whole room. 

  • Generic  - The  light bulb is controlled separate from the rest of the room.

Reset the light bulb:

  • Toggle the power switch on and off 7 times with 1 second intervals.

  • When you turn the power on after this process the light bulb will blink 2 times. This indicates that the light bulb is no longer paired to your smart home system and can be paired again with the same gateway or a new one.


  • The light bulb flashes two times when it is turned on - The light bulb is not paired to a gateway and is ready to pair.

  • The light bulb flashes three times in regular intervals - This is an indication that the security alarm has been activated on your system. Resolve the alarm to stop the flashing.

  • The light bulb never turns on - The light bulb is defect and must be replaced.

  • The light bulb is not found during scan - follow the reset routine and try to scan for the device..